www.dl2rum.de

When using RL with WSJT-X, I typically have the Log Station Info window open to immediately see where a station is located. It’s a minor issue, but the station info (name, QTH, and state) is shown in the main logging window, but is not retained in the logged QSO when saved via command from WSJT-X. If I save the QSO within RL, it includes this information. Is it possible to save this information when the QSO is automatically logged from WSJT-X?

Thanks,
Mike
AG7AB

Never mind. When I posted this, I see related posts on this subject. I will review and try the suggestions.

Edit: Yes, after telling RL not to save QSO's, manually saving works fine, as discussed by K7DZE earlier this year. Thanks.

Mike
AG7AB