www.dl2rum.de

I set up WSJT, RUMlog and GridTracker to listen to 224.0.0.1. Sitting here on the couch, I have no radio connected. When entering a callsign and a grid, these information become visible asap in both apps. It seems it works as expected. You said, it worked before on your side? Yes! That is good to ...

What happens when you keep the multicast address field empty in RUMlog? This may not work as expected. If I leave the multicast field empty, there is no change in behavior for either scenario. Both JT-Bridge and GridTracker are picking up the UDP traffic from WSJT-X on the multicast address, though.

This sounds normal to me. WSJT-X sends every 15 - 20 seconds a status message ( Here I am ), this message initiates the Checked in message. RUMlog doesn't show always the WSJT-X mode, the mode will be saved with a logging a QSO. But this depends on your CAT configuration. A screen shot would be ...

As far as I know, JT_Bridge works fine with RUMlog. So Grid Tracker may cause the problem. What happens when you quit this app? You can try to set the broadcast address inn WSJT-X to 192.168.1.255 or the equivalent in your network. Thanks, Tom! I reset the UDP broadcast port in WSJT-X to 192.168.20 ...

Hello All, I am having an issue with RUMlogNG correctly detecting multicast UDP packets from WSJT-X. This setup was working properly just a few days ago, and to the best of my knowledge none of the software pieces have been updated in any meaningful way. With WSJT-X set to broadcast UDP reports on ...